Freescale-semiconductor Target Interface MMDS0508 Manuel d'utilisateur télécharger pdf (Page 21)

Connector Information

Power Supply Fuse Replacement

3–21MMDS0508 Target Interface

2. Insert a small screwdriver at the tab on the right edge of the switch/connector assembly.

(Figure 1 shows where to insert the screwdriver.) Gently pry open the assembly door,

which swings open to the left.

3. Remove the fuse holder from the switch/connector assembly. Remove the fuse from the

holder.

4. Insert the replacement fuse into the holder. Then re-install the holder in the switch/

connector assembly. Make sure that the fuse holder arrow points down. Close the

assembly door.

5. Reconnect the power cord. This completes fuse replacement.

Freescale Semiconductor, Inc.

For More Information: www.freescale.com

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 85 86

Pas de commentaire

Freescale-semiconductor Target Interface MMDS0508 Manuel d'utilisateur Page 21