Freescale-semiconductor Microcontrollers Manuel d'utilisateur télécharger pdf (Page 827)

Debugger Engine Commands

Debugger Commands

Microcontrollers Debugger Manual

The STOP command stops execution of the emulation processor. Use the Go G command

to start the emulator.

NOTE The STOP command ends as soon as the PC is changed.

Debugger engine.

Current application debugging is stopped.

The T command executes one or more instructions at a specified address, or at the current

address (the address in the program counter). The T command traces into subroutine calls

and software interrupts. For example, if the current instruction is a Branch to Subroutine

instruction (BSR), the BSR is traced, and execution stops at the first instruction of the

subroutine. After executing the last (or only) instruction, the T command displays the

contents of the CPU registers, the instruction bytes at the new address in the program

counter and a mnemonic disassembly of the current instruction.

This command can be stopped by typing the Esc key.

Pas de commentaire

Freescale-semiconductor Microcontrollers Manuel d'utilisateur Page 827