Freescale Semiconductor Microcontrollers Manuel d'utilisateur télécharger pdf (Page 299)

HC08 Full Chip Simulation

Configuration Procedure

Microcontrollers Debugger Manual

Clear input and output buffer for SLC simulation

SLCDI Command

The SLCDI command is used to simulate SLIC input packets. The first input must be of

type “identifier.” Subsequent bytes may either be “data” or “identifier.” After the SLIC

Data IN buffer is filled with some data, the SLIC simulation module begins reception of

the data packet as soon as it is properly configured and turned on within the user’s

firmware. In Byte Transfer Mode, the designation of a byte as either “data” or “identifier”

has no effect. The SLIC data input buffer can store up to 256 bytes.

Bring up the SLIC IN buffer.

Figure 11.44 SLIC Data Input Configuration Dialog Box

Figure 11.45 SLIC Input Data Buffer

Pas de commentaire

Freescale Semiconductor Microcontrollers Manuel d'utilisateur Page 299