Freescale Semiconductor Microcontrollers Manuel d'utilisateur télécharger pdf (Page 674)

100

101

ColdFire P&E Multilink/Cyclone Pro Connection

First Steps From Within an Existing Project

674

Microcontrollers Debugger Manual

Trigger Module Settings

Select MultilinkCyclonePro > Trigger Module Settings to open the Trigger Module

Settings dialog. Refer to the Debugger ColdFire On-chip DBG Module User Interface

manual for all related information.

Bus Trace

Select MultilinkCyclonePro > Bus Trace to open the Trace component window within the

debugger main window. Refer to the Debugger ColdFire On-chip DBG Module User

Interface manual for all related information.

Flash

Select MultilinkCyclonePro > Flash to open the Non-Volatile Memory Control dialog

box. For more information see Flash Programming

P&E Multilink/Cyclone Pro Setup Dialog

Box

In the communication tab, the communication protocol between the debugger and P&E

driver display can be activated. The protocol is displayed in the Command window. Use

this option only when requested by the Support team.

Figure 29.6 P&E Multilink/Cyclone Pro Setup Dialog Box - Communication Tab

In the communication tab, checking Disable maskable ISR’s when stepping option

provides a way to debug without diving in pending program ISR’s. When this option is

set, interrupts are masked before stepping as if changing directly the interrupt level in the

SR core register. When the step is performed, the interrupt level is reverted to previous

state, and if necessary, adjusted according to last executed instruction (when the stepped

instruction affects the interrupt level).

1 2 ... 669 670 671 672 673 674 675 676 677 678 679 ... 891 892

Commentaires sur ces manuels

Pas de commentaire

Freescale Semiconductor Microcontrollers Manuel d'utilisateur Page 674

Commentaires sur ces manuels