Freescale Semiconductor Microcontrollers Manuel d'utilisateur télécharger pdf (Page 732)

100

101

Debugger Engine Commands

Commands Overview

732

Microcontrollers Debugger Manual

Command Syntax

To display the syntax of a command, type the command followed by a question mark.

Syntax Example:

in>printf?

PRINTF (<format>, <expression>, <expression>, ...)

Available Command Lists

Commands described on the following pages are sorted into 5 groups, according to their

specific actions or targets. However, these groups have no relevance in the use of these

commands. A list of all commands in their respective group is given below.

Kernel Commands

Kernel commands are commands that can be used to build command programs. They can

only be used in a debugger command file, since the Command Line component can only

accept one command at a time. It is possible to build powerful programs by combining

Kernel commands with Base commands, Common commands and Component specific

commands. Table 34.1

contains all available Kernel commands.

Table 34.1 List of Kernel Commands

Command, Syntax Short Description

A Affects a value

Sets a time delay for command execution

CALL

fileName[;C][;NL] Executes a command file

DEFINE

symbol [=] expression Defines a user symbol

ELSE

Other operation associated with IF command

ELSEIF

condition Other conditional operation associated with IF

command

ENDFOCUS

Resets the current focus (refer to FOCUS

command)

ENDFOR

Exits a FOR loop

ENDIF

Exits an IF condition

1 2 ... 727 728 729 730 731 732 733 734 735 736 737 ... 891 892

Commentaires sur ces manuels

Pas de commentaire

Freescale Semiconductor Microcontrollers Manuel d'utilisateur Page 732

Commentaires sur ces manuels